Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2008 >> Sedona Base >> Repair and Diagnosis >> Engine Performance >> System >> DTC Troubleshooting Procedures (2 Of 2) >> DTC P0647 A/C Clutch Relay Control Circuit High >> Component Inspection

Component Inspection

  1. Check A/C relay
    1. IG "OFF".
    2. Disconnect A/C relay.
    3. Measure the resistance between terminal 2 and 3 of A/C relay.
    4. Measure the resistance between terminal 1 and 4 of A/C relay.

      SPECIFICATION 

      RESISTANCE SPECIFICATION CHART

      Terminal Power approval
      1-4 NO
      2-3 YES
      (About 70-120Ω)
      Fig 1: Measuring Resistance Between Terminal 1 And 4 Of A/C Relay
      G04883533Courtesy of KIA MOTORS AMERICA, INC.
    5. Is the measured resistance within specification?

      YES 

      • Substitute with a known-good PCM and check for proper operation. If the problem is corrected, replace PCM and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

      NO 

      • Substitute with a known-good A/C relay and check for proper operation. If the problem is corrected, replace A/C relay and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
    NOTE: There is a memory reset function on scan tool that can erase optional parts automatically detected and memorized by PCM. After testing PCM on the vehicle, use this function to reuse the PCM on the others
scientia non olet · About Mike's Workshop Manuals