Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2008 >> Optima EX, 2.4 3 >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> DTC Troubleshooting Procedures (2 Of 2) - 2.4L >> DTC P0506 Idle Air Control System-Rpm Lower Than Expected >> Component Inspection >> Notes

Component Inspection: Notes

NOTE: It is necessary to perform the TPS adaptation procedure with Scan tool when the throttle body assembly or ECM is replaced.
  1. Erase previous TPS adaptation value using Scan tool.
  2. Ignition "OFF" and then "ON" without cranking. Wait for 10 seconds under enable conditions

    Enable conditions: Battery > 10V & Intake Air Temp. > 5.3°C (41.5°F) & 5.3°C (41.5°F)

    Engine Coolant Temp. < 99.8°C (211.6°F)

  3. After TPS adaptation, the system normality should be confirmed by reading out "FMY" on the Scan Tool
scientia non olet · About Mike's Workshop Manuals