Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2008 >> Magentis 2.7 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Automatic Transaxle System) >> DTC P0708 Transaxle Range Switch - High Input >> Signal Circuit Inspection

Signal Circuit Inspection

WARNING: This page is about a different car, the 2007 Kia Optima, 2007 Kia Magentis, 2006 Kia Optima, and 2006 Kia Magentis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition "OFF".
  2. Disconnect "TRANSAXLE RANGE SWITCH" and "TCM (PCM)" connector.
  3. Measure resistance between each terminals of the sensor harness to check for Short.

    Specification: Infinite

    Fig 1: Measuring Resistance Between Terminals Of Sensor Harness
    G04805089Courtesy of KIA MOTORS AMERICA, INC.
  4. Is resistance within specifications?

    YES  : --> Go to "COMPONENT INSPECTION " procedure.

    no  : --> Check for Short in harness. Repair as necessary and Go to "VERIFICATION OF VEHICLE REPAIR " procedure.

scientia non olet · About Mike's Workshop Manuals