Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2008 >> Magentis 2.7 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Automatic Transaxle System) >> DTC P0707 Transaxle Range Switch - Low Input >> Component Inspection

Component Inspection

WARNING: This page is about a different car, the 2007 Kia Optima, 2007 Kia Magentis, 2006 Kia Optima, and 2006 Kia Magentis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition "OFF".
  2. Remove "TRANSAXLE RANGE SWITCH".
  3. Measure the resistance between each terminal of the sensor.

    Specification: Approx. 0 Ω

    Fig 1: Measuring Resistance Between Terminal Of Sensor
    G04805087Courtesy of KIA MOTORS AMERICA, INC.
  4. Is resistance within specifications?

    YES  : --> Substitute with a known-good PCM/TCM and check for proper operation. If the problem is corrected, replace PCM/TCM as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    no  : --> Replace "TRANSAXLE RANGE SWITCH" as necessary and Go to "VERIFICATION OF VEHICLE REPAIR " procedure.