Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2007 >> Spectra5 2.0 1, Standard >> Repair and Diagnosis >> Engine Performance >> System >> DTC Troubleshooting Procedures >> Inspection Chart For Diagnostic Trouble Codes (DTC) >> DTC P0125 Insufficient Coolant Temperature For Closed Loop Fuel Control >> Component Inspection

Component Inspection

  1. Ignition "OFF".
  2. Disconnect ECTS connector.
  3. Measure resistance between terminals 1 and 3 of the sensor connector (Component side).

    SPECIFICATION 

    ECTS RESISTANCE SPECIFICATIONS

    Temperature ECTS Resistance (Ω) Temperature ECTS (Resistance (Ω)
    (°C) (°F) (°C) (°F)
    -20 -4 14.13 ~ 16.83 40 104 1.15
    0 32 5.79 60 140 0.59
    20 68 2.31 ~ 2.59 80 176 0.32
    Fig 1: Measuring Resistance Between Terminals 1 And 3 Of Sensor Connector
    G05115471Courtesy of KIA MOTORS AMERICA, INC.
  4. Is resistance within the specification?

    YES 

    • Check for poor connection between PCM and component: backed out terminal, improper mating, broken locks or poor terminal to wire connection. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure,

    NO 

    • Check ECTS for contamination, deterioration, or damage. Substitute with a known-good ECTS and check for proper operation. If the problem is corrected, replace ECTS and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
scientia non olet · About Mike's Workshop Manuals