Power Supply Circuit Inspection

WARNING: This page is about a different variant/trim than selected.

Remove "OIL PAN".
Ignition "ON", Engine "OFF".
Connect the "C106-3 and Shift CM" connector.
Measure resistance between terminal "4" of the TURBINE SENSOR harness connector and chassis ground.
Specification : approx. 12V

Fig 1: Measuring Resistance Between Terminal No. 4 Of Turbine Sensor Harness Connector And Chassis Ground
Courtesy of KIA MOTORS AMERICA, INC.
Is voltage within specifications ?
YES
- Go to "GROUND CIRCUIT INSPECTION " procedure.
NO
- Check for open or short in harness. Repair as necessary and Go to "VERIFICATION OF VEHICLE REPAIR " procedure. If power circuit in harness is OK, Substitute with a known-good Shift CM and check for proper operation. If the problem is corrected, replace Shift CM as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.