Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2007 >> Sorento Base, A5SR2 >> Repair and Diagnosis >> Engine Performance >> System >> DTC Troubleshooting Procedures (2 Of 2) >> Troubleshooting For DTC >> DTC P0448 EVAP. Emission System-Vent Control Circuit Shorted >> Component Inspection

Component Inspection

  1. Check CCV
    1. Ignition "OFF"
    2. Measure resistance between terminals "1" and "2" of the CCV connector.

      Specification: Approx. 15.5-18.5 Ω (20°C (68°F)

      Fig 1: Measuring Resistance Between Terminals "1" And "2" Of CCV Connector
      G05118972Courtesy of KIA MOTORS AMERICA, INC.
    3. Monitor the CCV signal waveform and verify that the ground voltage is less than approx. 0.3V (1) and the surge voltage (2) is between 40 V and 60 V.
      Fig 2: CCV Signal Waveform
      G05163555Courtesy of KIA MOTORS AMERICA, INC.
    4. Is the CCV normal?

      YES 

      • Substitute with a known-good ECM and check for proper operation.
      • If the problem is corrected, replace ECM and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

      NO 

      • Substitute with a known-good CCV and check for proper operation.
      • If the problem is corrected, replace CCV and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
      NOTE: There is a memory reset function on scan tool that can erase optional parts automatically detected and memorized by ECM. After testing ECM on the vehicle, use this function before reusing the ECM
scientia non olet · About Mike's Workshop Manuals