Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2007 >> Sorento Base, A5SR2 >> Repair and Diagnosis >> Brakes >> Traction Control >> Abs (Anti-Lock Brake System) >> Diagnostic Trouble Code Chart (DTC) >> DTC C1274 G-Sensor - Electrical >> Monitor Scan Tool Data

Monitor Scan Tool Data

  1. Connect scan tool to Data Link Connector (DLC)
  2. Ignition "ON" & Engine "OFF".
  3. Monitor the "G-sensor" parameter on the Scan tool.

    Specification : Approx. ± 0.01 G

    Fig 1: Scan Tool Display - Wheel Spd Sensor FL
    G05119620Courtesy of KIA MOTORS AMERICA, INC.
  4. Is parameter displayed within specifications?

    YES 

    • Fault is intermittent caused by poor connection in G-sensor harness and/or HECU's connector or was repaired and HECU memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

    • Go to next procedure.
scientia non olet · About Mike's Workshop Manuals