Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2007 >> Sedona Base >> Repair and Diagnosis >> Brakes >> Traction Control >> Abs (Anti-Lock Brake System) >> Diagnostic Trouble Code Chart(DTC) >> DTC C1623 Can Time-Out Steering Angle Sensor >> Component Inspection

Component Inspection

  1. Ignition "OFF".
  2. Engine "ON".
  3. Does warning lamp remain On?

    YES 

    • Substitute with a known-good steering angle sensor and check for proper operation. If problem is corrected, replace sensor and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
    • Substitute with a known-good HECU and check for proper operation. If problem is corrected, replace HECU and then go to "VERIFICATION OF VEHICLE REPAIR " procedure

    NO 

    • Fault is intermittent caused by poor connection in power harness (IGN+), inoperative Generator and/or inoperative HECU or was repaired and HECU memory was not cleared. Go to the applicable troubleshooting procedure.
scientia non olet · About Mike's Workshop Manuals