Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2007 >> Sedona Base >> Repair and Diagnosis >> Brakes >> Traction Control >> Abs (Anti-Lock Brake System) >> Diagnostic Trouble Code Chart(DTC) >> DTC C1503 TCS/ESC Switch Error >> Power Supply Circuit Inspection

Power Supply Circuit Inspection

  1. Ignition "ON" & Engine "OFF" & ESC Switch "ON".
  2. Measure voltage between terminal "31" of the HECU harness connector and chassis ground.

    Specification: Approx B+

    Fig 1: Measuring Voltage Between Terminal Of HECU Harness Connector And Chassis Ground
    G04883883Courtesy of KIA MOTORS AMERICA, INC.
  3. Is the measured voltage within specifications?

    YES 

    • Fault is intermittent caused by open or short in ESC switch line, inoperative ESC switch or was repaired and HECU memory was not cleared. Go to the applicable troubleshooting procedure.

    NO 

    • Check for damaged harness and poor connection in the power harness between the battery terminal(+) and the terminal "31" of the HECU harness connector. Check for open or blown 10 A fuse referring to "Circuit Diagram". Repair as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
scientia non olet · About Mike's Workshop Manuals