Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2007 >> Rondo Base >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle System (F4A42) >> Automatic Transaxle System >> DTC P0885 A/T Relay Circuit Malfunction >> Component Inspection

Component Inspection

  1. Ignition "OFF".
  2. Remove "A/T CONTROL RELAY"
  3. Measure the resistance between each terminal of the sensor.

    Specification: Shown below

    TERMINALS SPECIFICATION

    Item Terminal No
    Resistance 1 (red) - 3 (pink) INFINITE
    2 (black) - 4 (pink)  
    supply (B+) to number 4 and supply (B-) to number 2. 1 (red) - 3 (pink) 0 Ω
    Fig 1: Measuring Resistance Between Terminal 2 And 4 Of A/T Control Relay Harness Connector And Chassis Ground
    G05186431Courtesy of KIA MOTORS AMERICA, INC.
  4. Is resistance within specification?

    YES 

    • Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

scientia non olet · About Mike's Workshop Manuals