Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2007 >> Rondo Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Automatic Transaxle System (A5GF1)) >> Automatic Transaxle System >> DTC P0885 A/T Relay Circuit Malfunction >> Monitor SCANTOOL Data

Monitor SCANTOOL Data

WARNING: This page is about a different variant/trim than selected.
  1. Connect scantool to data link connector (DLC).
  2. Ignition "ON" & Engine "OFF".
  3. Monitor the "A/T CON. RELAY VOLT" parameter on the scantool.

    Specification : Approx. B+

    Fig 1: Monitor Scantool Data - A/T CON RELAY VOLT Parameter
    G04882305Courtesy of KIA MOTORS AMERICA, INC.
  4. Is A/T RELAY VOLT within specifications?

    YES 

    • Fault is intermittent caused by poor contact in the sensor's and/or TCM (PCM)'s connector or was repaired and TCM (PCM) memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

scientia non olet · About Mike's Workshop Manuals