Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2007 >> Rio Base, Standard >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Blower Controls >> Blower Unit >> Replacement

Blower Unit: Replacement

  1. Disconnect the negative (-) battery terminal.
  2. Remove the crash pad.(Refer to INTERIOR )
  3. Disconnect the connectors from the fresh and recirculation actuator, the blower motor and power mosfet.
  4. Remove the cowl cross bar assembly.(Refer to INTERIOR )
  5. Remove the blower unit (A) from the heater unit after loosening a mounting bolt and 3 screws.
    Fig 1: Identifying Blower Unit And Screws
    G04863899Courtesy of KIA MOTORS AMERICA, INC.
    NOTE: Make sure that there is no air leaking out of the blower and duct joints.
  6. Install in reverse order of removal.
scientia non olet · About Mike's Workshop Manuals