Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2007 >> Rio Base, Standard >> Repair and Diagnosis >> Engine Performance >> System >> DTC Troubleshooting Procedures (1 Of 2) >> DTC P0030 Ho2S Heater Control Circuit (Bank 1 / Sensor 1) >> Component Inspection

Component Inspection

  1. Check resistance.
    1. IG "OFF".
    2. Disconnect HO2S (S1) connector.
    3. Measure resistance between terminal 3 and 4 of HO2S (S1 ) (Component Side)
      RESISTANCE SPECIFICATION

      ITEM Specification
      Heater Resistance(Ω) Approx. 9.0Ω at 20 °C (68°F)
      Fig 1: Measuring Resistance Between Terminal 3 And 4 Of HO2S (S1)
      G04862056Courtesy of KIA MOTORS AMERICA, INC.
    4. Is the measured resistance within specification?

      YES 

      • Substitute with a known - good ECM/PCM and check for proper operation.
      • If the problem is corrected, replace ECM/PCM and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
      NOTE: There is a memory reset function on scantool that can erase optional parts automatically detected and memorized by ECM/PCM.
      Before or after testing ECM/PCM on the vehicle, use this function to reuse the ECM/PCM.

      NO 

      • Substitute with a known - good HO2S (S1) and check for proper operation.
      • If the problem is corrected, replace HO2S (S1) and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
scientia non olet · About Mike's Workshop Manuals