Monitor SCANTOOL Data
WARNING: This page is about a different car, the 2007 Kia Sedona and 2006 Kia Sedona. However, it is still accessible from the selected car via links, so may be relevant.
- Connect scantool to Data Link Connector(DLC).
- Ignition "ON" & Engine "ON".
- Press the brake pedal.
- Monitor the "Pressure sensor" parameter on the Scantool.
Specification: Approx. 60 bar ~ 150 bar (There are difference in displayed parameter according to braking force)
- Whenever brake pedal is pushed down, is the pressure sensor's scantool data changed?
YES
- Fault is caused by having been repaired and HECU memory was not cleared. Clear the DTC and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Go to "COMPONENT INSPECTION " procedure.