Signal Circuit Inspection

WARNING: This page is about a different variant/trim than selected.

Ignition "OFF".
Disconnect "TRANSAXLE RANGE SWITCH" and "TCM (PCM)" connector.
Measure resistance between each terminals of the sensor harness to check for Short.
Specification: Infinite

Fig 1: Measuring Resistance Between Terminals Of Sensor Harness
Courtesy of KIA MOTORS AMERICA, INC.
Is resistance within specifications?
YES : --> Go to "COMPONENT INSPECTION " procedure.

no : --> Check for Short in harness. Repair as necessary and Go to "VERIFICATION OF VEHICLE REPAIR " procedure.