Steering Pad Switch: Installation

WARNING: This page is about a different car, the 2006 Lexus IS 350 and 2006 Lexus IS 250. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL STEERING PAD SWITCH ASSEMBLY
1. Engage the 2 claws and install the steering pad switch.
2. Install the screw.
  
  Fig 1: Identifying Screw
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Engage the 2 claws and install the steering pad switch.
4. Install the screw.
5. Connect the connector to the spiral cable.
  
  Fig 2: Identifying Screw
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. Connect the cruise connector and install the connector clamp.
INSTALL STEERING PAD (See INSTALLATION )
INSTALL LOWER NO. 3 STEERING WHEEL COVER (See INSTALLATION )
INSTALL LOWER NO. 2 STEERING WHEEL COVER (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
NOTE: Some systems need initialization when disconnecting the cable from the negative battery terminal (See INITIALIZATION ).
INSPECT SRS WARNING LIGHT
(see DIAGNOSIS SYSTEM )

Fig 3: Identifying Cruise Connector And Connector Clamp
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002