Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2007 >> Amanti >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle System >> Automatic Transaxle System >> DTC P0742 Torque Converter Clutch Circuit - Stuck On >> Monitor Scan Tool Data

Monitor Scan Tool Data

  1. Connect scan tool to data link connector (DLC).
  2. Engine "ON".
  3. Select "D RANGE" and drive vehicle.
  4. Monitor the "TORQUE CONVERTER (DAMPER) CLUTCH" parameter on the scan tool.

    Specification: TCC SLIP > 5 RPM

    Fig 1: Scan Tool Display - Current Data
    G04805139Courtesy of KIA MOTORS AMERICA, INC.
  5. Is TCC SLIP" within specifications?

    YES 

    • Fault is intermittent caused by poor contact in the sensor's and/or TCM (PCM)'s connector or was repaired and TCM (PCM) memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

scientia non olet · About Mike's Workshop Manuals