Monitor DTC Status

Check DTC Status
1. Connect scan tool to Data Link Connector (DLC).
2. IG "ON".
3. Select "Diagnostic Trouble Codes (DTCs)" mode, and then Press F5(INFO) to check DTC's information from the DTCs menu
4. Read "DTC Status" parameter.
  
  Fig 1: Scan Tool Display - DTC Status
  Courtesy of KIA MOTORS AMERICA, INC.
5. Is "Present" Fault displayed?
  YES
  - Check that hose between canister and tank is correctly connected and undamaged.
  - Repair or replace as necessary and then, go to "COMPONENT INSPECTION " procedure.
  NO
  - Fault is intermittent caused by PCM memory was not cleared after repair.
  - Erase DTC and go to "VERIFICATION OF VEHICLE REPAIR " procedure.