Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2007 >> Amanti >> Repair and Diagnosis >> Engine Performance >> System >> DTC Troubleshooting Procedures (1 Of 2) >> DTC P0222 Throttle/Pedal Position Sensor/Switch "B" Circuit Low Input >> Component Inspection

Component Inspection

  1. Check TPS
    1. IG "OFF" and disconnect TPS connector.
    2. Measure resistance between terminals 1 and 5 of TPS connector.(Component side)

      Specification : 2.7 ~ 4.1 kΩ

      Fig 1: Measuring Resistance Between Terminals 1 And 5 Of TPS Connector
      G05116571Courtesy of KIA MOTORS AMERICA, INC.
    3. Is the measured resistance within specification?

      YES 

      • Substitute with a known - good PCM and check for proper operation. If the problem is corrected, replace PCM and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

      NO 

      • Substitute with a known - good TPS and check for proper operation. If the problem is corrected, replace TPS and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
    NOTE: There is a memory reset function on scan tool that can erase optional parts automatically detected and memorized by PCM. After testing PCM on the vehicle, use this function before reusing the PCM
    CAUTION: Procedure of ETS Initialization
    1. Erase the trouble codes on PCM
    2. Turn the ignition key off and keep this condition until the main relay is turned off.(10 sec.)
    3. Turn ignition key on more than 1 second to record the throttle motor position on the EEPROM
scientia non olet · About Mike's Workshop Manuals