Component Inspection

Check OCV
1. IG "OFF" and disconnect OCV connector.
2. Measure resistance between terminal 1 and 2 of OCV. (Component Side)
  Specification : 6.7 ~ 7.7 Ω at 20°C (68°F)
  
  Fig 1: Measuring Resistance Between Terminal 1 And 2 Of OCV
  Courtesy of KIA MOTORS AMERICA, INC.
3. Is the measured resistance within specification ?
  YES
  - Go to 2"OCV Actuation Test" as follows.
  NO
  - Substitute with a known - good OCV and check for proper operation. If the problem is corrected, replace OCV and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
OCV Actuation Test
1. Connect scan tool and IG "ON".
2. Select "OCV" on the Actuation Test.
3. Activate "OCV" by pressing "STRT(F1)" key.
  (should hear a faint click from Oil Control solenoid Valve)
4. Repeat this procedure 4 or 5 times to ensure reliability.
  
  Fig 2: Scan Tool Screen Display - ACTUATION TEST
  Courtesy of KIA MOTORS AMERICA, INC.
5. Does OCV generate click sound during actuation test ?
  YES
  - Substitute with a known - good PCM and check for proper operation. If the problem is corrected, replace PCM and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
  NOTE: There is a memory reset function on scan tool that can erase optional parts automatically detected and memorized by PCM.
  Before or after testing PCM on the vehicle, use this function before reusing the PCM
  
  NO
  - Substitute with a known - good OCV and check for proper operation. If the problem is corrected, replace OCV and go to "VERIFICATION OF VEHICLE REPAIR " procedure.