Inspection Procedure

1. Connect a Hi-Scan (Pro) to the data link connector.
2. Turn ignition switch to ON position and monitor other DTCs.

Is any DTC relating to OTS set?

1. No:  Go to next step.
2. Yes: Do all repairs associated with those codes before proceeding with this procedure.

Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. See CONNECTOR INSPECTION PROCEDURE .

Are all connectors good?

1. Yes:  Go to next step.
2. No: Repair or replace it.

1. Turn ignition switch to OFF and disconnect OTS connector.
2. Measure resistance between the terminals 1 and 2 of OTS connector.

   Specification (OTS resistance):

   Fig 1: OTS Resistance Chart

   Courtesy of KIA MOTORS AMERICA, INC.
   Fig 2: Checking OTS Resistance

   Courtesy of KIA MOTORS AMERICA, INC.

Is resistance within specification?

1. Yes:  Proceed with ECM PROBLEM INSPECTION PROCEDURE .
2. No: Replace OTS.