Component Inspection

WARNING: This page is about a different car, the 2004 Kia Rio. However, it is still accessible from the selected car via links, so may be relevant.

Ignition "OFF"
Disconnect ECTS connector

Measure resistance between terminals 1 and 3 of the sensor connector (Component side)

Specification:

Fig 1: Measuring Resistance Between Terminals 1 And 3 Of Sensor Connector (Component Side)

RESISTANCE REFERENCE CHART

Temp. (°C)	Temp. (°F)	Resistance (kΩ)
-20	-4	13.24~16.83
20	68	2.27~2.64
80	176	0.207~0.429

Is resistance within the specification?
YES
1. Check for poor connection between ECM and component: backed out terminal, improper mating, broken locks or poor terminal to wire connection. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure
NO
1. Check ECTS for contamination, deterioration, or damage. Substitute with a known-good ECTS and check for proper operation. If the problem is corrected, replace ECTS and then go to "VERIFICATION OF VEHICLE REPAIR " procedure