Monitor Scantool Data
- Connect scantool to Data Link Connector (DLC).
- IG KEY: ON, Engine: ON
- Monitor the power steering signal on "Current data" mode.
- Specification:
- While not turning steering wheel: "OFF"
- While turning steering wheel slowly: "ON"
- Specification:
- Is the power steering switch operating well?
YES
- Fault is intermittent caused by poor contact in the sensor's and/or ECM's connector.
- Fault was repaired and ECM memory was not cleared.
- If the problem works out, Go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Go to "Inspection & Repair" procedure.