Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2004 >> Sorento EX, 4WD, Part Time >> Repair and Diagnosis >> Engine Performance >> Specifications >> Fuel System & Fault Isolation >> DTC Troubleshooting Procedures >> DTC P0446: EVAP Emission System - Vent Control Circuit >> W/Harness Inspection >> Control Circuit Inspection

Control Circuit Inspection

Check for Open in Harness 

  1. IG KEY: OFF, Engine: OFF
  2. Disconnect CCV connector and ECM connector.
  3. Measure resistance between terminal 1 of the CCV harness connector and A35 of ECM harness connector.
    1. Specification: Approx. 0Ω
      Fig 1: Measuring Resistance Between Terminal 1 Of CCV Harness Connector And A35 Of ECM Harness Connector
      G07703300
  4. Is the resistance near the specified value?

    YES

    1. Go to "Check for Short to Ground" procedure.

    NO

    1. Repair open in harness, Go to "VERIFICATION OF VEHICLE REPAIR " procedure.

Check for Short to Ground 

  1. IG KEY: OFF, Engine: OFF
  2. Disconnect CCV connector.
  3. Measure resistance between terminal 1 of the CCV harness connector and chassis ground.
    1. Specification: infinite
      Fig 2: Measuring Resistance Between Terminal 1 Of CCV Harness Connector And Chassis Ground
      G07703301
  4. Does the resistance indicate open?

    YES

    1. Go to "COMPONENT INSPECTION " procedure.

    NO

    1. Repair short to chassis ground in harness, Go to "VERIFICATION OF VEHICLE REPAIR " procedure.