Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2004 >> Sorento EX, 4WD, Part Time >> Repair and Diagnosis >> Engine Performance >> Specifications >> Fuel System & Fault Isolation >> DTC Troubleshooting Procedures >> DTC P0122: Throttle/Pedal Position Sensor/Switch A Circuit Low Input >> W/Harness Inspection >> Signal Circuit Inspection

Signal Circuit Inspection

Check for Short to Ground in Harness 

  1. IG KEY: OFF, Engine: OFF
  2. Disconnect TPS connector (B-13).
  3. Measure resistance between terminal 3 of the TPS harness connector B-13 and chassis ground.
    1. Specification: infinite (infinite Ω)
      Fig 1: Measuring Resistance Between Terminal 3 Of TPS Harness Connector B-13 And Chassis Ground
      G07702959
  4. Is the resistance near the specified value?

    YES

    1. Go to "Check for Open in Harness" procedure.

    NO

    1. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

Check for Open in Harness 

  1. IG KEY: OFF, Engine: OFF
  2. Disconnect TPS connector (B-13) and ECM connector.
  3. Measure resistance between terminal 3 of the TPS harness connector B-13 and C9 of the ECM harness connector B-01.
    1. Specification: Approx. 0Ω.
      Fig 2: Measuring Resistance Between Terminal 3 Of TPS Harness Connector B-13 And C9 Of ECM Harness Connector B-01
      G07702960
  4. Is the resistance near the specified value?

    YES

    1. Go to "COMPONENT INSPECTION " procedure.

    NO

    1. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.