Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2004 >> Sorento EX, 4WD, Part Time >> Repair and Diagnosis >> Engine Performance >> Specifications >> Fuel System & Fault Isolation >> DTC Troubleshooting Procedures >> DTC P0102: Mass Or Volume Air Flow Circuit Low Input >> Component Inspection

Component Inspection

  1. Connect scantool to Data Link Connector (DLC).
  2. Warm up the engine to normal operating temperature.
  3. Monitor the "MASS AIR FLOW" parameter on scantool.
    1. Specification
      1. Approx. 900 mV at IG KEY: ON & Engine: OFF
      2. Approx. 1,300~1,500 mV at idle (no load)
      3. Approx. 1,700~1,800 mV at 2000 RPM (no load)
        Fig 1: Scantool Screen Display - Mass Air Flow Parameter
        G07702880
  4. Is the sensor's signal near the specified value?

    YES

    1. MAF sensor is OK.
    2. Possibility of ECM fail.
    3. Test with a new ECM and check for proper operation. If problem is corrected replace ECM and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO

    1. Test with a new MAF sensor and check for proper operation. If problem is corrected, replace MAF sensor.