Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2004 >> Amanti >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Air Bag Module (Drive Side)) >> Air Bag Module (Driver) And Clock Spring >> Installation

Air Bag Module (Driver) And Clock Spring: Installation

WARNING: This page is about a different car, the 2006 Kia Amanti and 2005 Kia Amanti. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative (-) cable from battery and wait for at least three minutes.
    Fig 1: Disconnecting Negative (-) Cable From Battery
    G03877330Courtesy of KIA MOTORS AMERICA, INC.
  2. Remove ignition key from the vehicle.
  3. Connect the Driver Airbag (DAB) harness connectors, then install a Driver Airbag (DAB) module on the steering wheel.
  4. Secure the Driver Airbag (DAB) with the new mounting bolts.

    Tightening Torque (DAB Mounting Bolt): 7.8 ~ 10.8 N.m (5.8 ~ 8.0 lb.ft)

  5. Connect the battery negative cable.
  6. After installing the airbag, confirm proper system operation:
    • Turn the ignition switch ON; the SRS indicator light should blink for about six times and then go off.
    • Make sure both horn buttons work.
scientia non olet · About Mike's Workshop Manuals