Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2003 >> Spectra Base, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Diagnosis & Overhaul >> Automatic Transaxle Control System >> Transaxle Range (Tr) Switch >> Adjustment

Transaxle Range (Tr) Switch: Adjustment

  1. Disconnect negative battery cable.
  2. Pull data link connector upward from MAF sensor.
  3. Disconnect air temperature sensor connector and MAF sensor connector.
  4. Remove fresh air duct and air cleaner assembly.
  5. Remove nut. Disconnect selector cable.
  6. Rotate manual shaft to N position.
  7. Disconnect transaxle range switch connector.
  8. Loosen transaxle range switch mounting bolts.
  9. Connect ohmmeter.
  10. Adjust switch to point where there is continuity between terminals.
  11. Tighten two transaxle range switch mounting bolts.

    Tightening torque: 70-95 lb.in (7.9-10.7 N.m, 80-110 kg.cm) 

  12. Verify that the selector lever range position and transaxle range switch correspond.
  13. Connect transaxle range switch connector.
  14. Connect selector cable and tighten nut.

    Tightening torque: 24-33 lb.ft (32-46 N.m, 3.2-4.7 kg.m) 

  15. Install air cleaner assembly, and fresh air duct.
  16. Connect air temperature sensor connector and MAF sensor connector.
  17. Install data link connector to MAF sensor.
  18. Connect negative battery cable.
scientia non olet · About Mike's Workshop Manuals