Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2002 >> Magentis SE, 2.7 8 >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Servicing - A/T >> Removal & Installation >> Shift Control >> Installation

Shift Control: Installation

  1. Apply a coating of chassis grease (SAE J310, NLGI No. 0) to the interior of the adjust bushing. Move the shift lever and the transaxle range switch to the Neutral position and install the transaxle control cable. See Figure.
  2. When connecting the control cable to the transaxle mounting bracket, install the clip until it contacts the control cable. See Figure.
  3. Install the shift lever assembly and connector. See Figure. Tighten to specification. See TORQUE SPECIFICATIONS . When connecting the control cable to the shift lever mounting bracket, install the clip until it contacts the control cable.
  4. Install the control cable, the key lock cable and the shift cable mounting bolt. See Figure. Tighten to specification. See TORQUE SPECIFICATIONS . Position the console and tighten 8 screws.
  5. Install the center panel after connecting 12V power outlet pin, then tighten 2 screws. See Figure.
  6. Install lever panel. Install 2 seat heater switches to the center panel. See Figure.
scientia non olet · About Mike's Workshop Manuals