Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 1995 >> Sephia LS, 1.6 1, Standard >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul >> Fuel System >> Oxygen Sensor >> Removal & Installation

Removal & Installation

  1. Oxygen sensor is mounted in exhaust pipe, below exhaust header. Sensor is equipped with a permanent pigtail which must be protected from damage when sensor is removed. Disconnect sensor connector and remove sensor.
  2. Sensor may be difficult to remove when engine temperature is less than 120°F (48°C). Ensure sensor is free of contaminants. DO NOT  use cleaning solvents of any type. Always use anti-seize compound on threads before installation. Tighten sensor to 22-36 ft. lbs. (30-49 N.m).
scientia non olet · About Mike's Workshop Manuals