Trailer Tow Module - Three Row Seating

REMOVAL 

1. Remove the cargo load floor. Refer to LOAD FLOOR, CARGO, REMOVAL AND INSTALLATION .

   Courtesy of CHRYSLER GROUP, LLC

   1 - Wire Harness Connector

   2 - Trailer Tow Module (TTM)

2. Disconnect the TTM wire harness connector.

   Courtesy of CHRYSLER GROUP, LLC

   1 - Wire Harness Connector

   2 - Trailer Tow Module (TTM)

3. Remove the TTM nuts and remove the TTM.

   Courtesy of CHRYSLER GROUP, LLC

   1 - TTM Nuts

   2 - TTM

INSTALLATION 

Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.

• After applying 12V power to the vehicle, use the WiTech tool to run the "ESS 150 Amp Fuse Check" routine.