Drivetrain Control Module (DTCM) - DTCS C1472-92 To U0101-87

• DTC Troubleshooting
  • C1472-92-Transfer Case Clutch Control-Performance Or Incorrect Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C1477-98-Transfer Case Clutch-Component Or System Over Temperature
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C149D-06-Clutch Calibration Not Learned-Algorithm Based Failures
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C149D-54-Clutch Calibration Not Learned-Missing Calibration
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C149D-55-Clutch Calibration Not Learned-Not Configured
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C14A1-74-Unintended Actuator Shaft Movement Detected-Actuator Slipping
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C14AA-56-Transfer Case Motor Position Sensor Supply-Invalid - Incompatible Configuration
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C14AA-62-Transfer Case Motor Position Sensor Supply-Signal Compare Failure
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C14AD-13-Transfer Case Range Position Sensor Supply-Circuit Open
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C14AD-14-Transfer Case Range Position Sensor Supply-Circuit Short To Ground Or Open
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C14AD-15-Transfer Case Range Position Sensor Supply-Circuit Short To Battery Or Open
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C2201-42-FDCM/DTCM Internal-General Memory Failure
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C2201-49-FDCM/DTCM Internal-Internal Electronic Failure
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C2201-55-FDCM/DTCM Internal-Not Configured
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C2203-00-Current VIN Missing-Mismatch-
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C2206-56-Vehicle Configuration Mismatch-Invalid - Incompatible Configuration
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C2210-4B-Ecu Over Temperature-Over Temperature
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P0602-00-Control Module Programming Error/Not Programmed
    • When Monitored
    • Set Condition
    • Possible Causes
    • Diagnostic Test
  • U0100-87-Lost Communication With ECM/Pcm A-Missing Message
  • U0101-87-Lost Communication With TCM-Missing Message