Smart Lighting Module (SLM)

NOTE:

Left side shown, right side similar.

REMOVAL

Remove the front lamp unit. Refer to UNIT, FRONT LAMP, REMOVAL AND INSTALLATION .
Remove the fasteners securing the Smart Lighting Module (SLM) to the front lamp unit.

Courtesy of CHRYSLER GROUP, LLC

1 - Fasteners

2 - Smart Lighting Module (SLM)
Disconnect the wire harness connector from the SLM.

Courtesy of CHRYSLER GROUP, LLC

1 - Wire Harness Connector

INSTALLATION

Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.

If replacing the module, verify the smart lighting module seal is installed properly and replace the module fasteners.
Tighten the fasteners securely.

Courtesy of CHRYSLER GROUP, LLC

1 - Smart Lighting Module (SLM) Seal

2 - Smart Lighting Module (SLM)
After replacing SLM modules, perform an ECU reset found under the Guided Diagnostics/Reset ECU menu in wiTECH. If DTCs or issues are present - a Proxi Configuration Alignment may be required followed by an ECU reset.