Removal And Installation

REMOVAL 

1. Remove the gear shift knob. Refer to KNOB, GEARSHIFT, REMOVAL AND INSTALLATION .
2. Remove the lift ring spring from on top of the lift ring.

   Courtesy of CHRYSLER GROUP, LLC

   1 - Lift Ring Spring

3. Remove the lift ring.

   Courtesy of CHRYSLER GROUP, LLC

   1 - Lift Ring

4. Using a trim stick or equivalent, separate the gearshift boot from the floor console while gently pulling up on the boot fabric.

   Courtesy of CHRYSLER GROUP, LLC

   1 - Gearshift Boot

5. Remove the gearshift boot from the shifter.

INSTALLATION 

Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.

1. With the shift knob removed, place the gearshift boot in position over the shift lever.
2. Install the gearshift boot and press it firmly into the floor console to engage the retention clips.

   Courtesy of CHRYSLER GROUP, LLC

   1 - Gearshift Boot

3. Install the lift ring.

   Courtesy of CHRYSLER GROUP, LLC

   1 - Lift Ring

4. Install the lift ring spring.

   Courtesy of CHRYSLER GROUP, LLC

   1 - Lift Ring Spring

5. Install the shifter knob. Refer to KNOB, GEARSHIFT, REMOVAL AND INSTALLATION .