Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2022 >> Wrangler Unlimited High Tide, Part Time T/Case Control >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Electronic Control Modules (Service Information) (2 Of 2) >> Module, Power Top Control, Full Open Retractable Roof (PTCM) >> Removal And Installation >> Power Top Control Module (PTCM) Retractable Roof

Power Top Control Module (PTCM) Retractable Roof

NOTE:

There are two power top roof motors equipped on this vehicle. The following procedural graphics are of the master motor with Power Top Control Module (PTCM), or right side motor. The left side motor, or the slave motor with no PTCM, is removed and installed in the same manner.

GC0183088Courtesy of CHRYSLER GROUP, LLC

REMOVAL 

  1. Disconnect and isolate the negative battery cable(s). Refer to 2.0L, BATTERY DISCONNECT AND CONNECT - SINGLE 12V BATTERY SYSTEM and/or 2.0L, BATTERY DISCONNECT - DUAL 12 VOLT BATTERY SYSTEM and/or 2.0L, 12-VOLT BATTERY DISCONNECT/CONNECT - PHEV and/or 3.0L, BATTERY DISCONNECT - DUAL 12 VOLT BATTERY SYSTEM and/or 3.6L, BATTERY DISCONNECT - DUAL 12 VOLT BATTERY SYSTEM and/or 3.6L, HYBRID, BATTERY DISCONNECT AND CONNECT - SINGLE 12V BATTERY SYSTEM and/or 6.4L, BATTERY DISCONNECT AND CONNECT - SINGLE 12V BATTERY SYSTEM .
  2. Remove the motor trim panel cover.
    GC0181165Courtesy of CHRYSLER GROUP, LLC
    1 - Fasteners
    2 - Roof Motor
  3. Disconnect the wire harness connector from the power top roof motor.
  4. Remove the fasteners securing the power top roof motor to the trim panel.
  5. Remove the power top roof motor from the vehicle.

INSTALLATION 

Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.

scientia non olet · About Mike's Workshop Manuals