Power Liftgate Module (PLGM)

REMOVAL 

1. Disconnect and isolate the negative battery cable(s). Refer to 3.6L, BATTERY DISCONNECT AND CONNECT or 5.7L, BATTERY DISCONNECT AND CONNECT .
2. Remove the right lower quarter trim panel. Refer to PANEL, QUARTER TRIM, REMOVAL AND INSTALLATION .

   Courtesy of CHRYSLER GROUP, LLC

   1 - Power LiftGate Module (PLGM)

   2 - Power LiftGate Module Latch

   3 - Wire Harness Connector

3. Disconnect the Power LiftGate Module (PLGM) wire harness connector.
4. Press the latch feature of the PLGM housing and pull the PLGM out and away from the body.
5. Remove the PLGM from the vehicle.

INSTALLATION 

Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.

• Verify that the module housing latch is fully engaged.
• Use the scan tool to perform the proxy alignment.
• Perform the power liftgate teach procedure. Refer to POWER LIFTGATE LEARN/RELEARN PROCEDURE .