Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2022 >> Compass Red >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Power Transfer Unit (Service Information)) >> Actuator, Shift >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Position the actuator on the PTU. Install and tighten the bolts to the proper torque specification. Refer to TORQUE SPECIFICATIONS 
  2. Connect the actuator wire harness connector.
  3. Install the right front tire and wheel assembly. Refer to REMOVAL AND INSTALLATION .
  4. Remove the support and lower the vehicle.
scientia non olet · About Mike's Workshop Manuals