Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2022 >> Cherokee Trailhawk >> Repair and Diagnosis >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Electronic Control Modules (Service Information) >> Module, Instrument Panel Cluster (IPC) >> Removal >> Instrument Panel Cluster

Instrument Panel Cluster

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the Instrument Panel Cluster (IPC) bezel. Refer to BEZEL, INSTRUMENT CLUSTER, REMOVAL .
  3. Disengage the gap hider clips at the bottom of the instrument cluster.
    GC0159211Courtesy of CHRYSLER GROUP, LLC
  4. Remove the upper (1) and lower (2) fasteners securing the IPC to the instrument panel.
  5. Pull the top of the IPC back and lift the IPC upward to remove.
    GC0187087Courtesy of CHRYSLER GROUP, LLC
  6. Move the steering column to its lowest position.
  7. Disconnect the instrument panel wire harness connector (2) from the back of the IPC (1).
    GC0160111Courtesy of CHRYSLER GROUP, LLC
  8. Remove the IPC (1) from the vehicle.
scientia non olet · About Mike's Workshop Manuals