Removal And Installation: Removal
To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts, buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the Mopar® Parts Catalog. Failure to follow these instructions may result in possible serious or fatal injury.
- Adjust the front seat to its most forward position for easiest access to the front seat belt and the B-pillar trim.
- Firmly grasp the top of the trim cover (2a) for the front seat belt turning loop height adjuster on the inside of the upper B-pillar and pull it away from the height adjuster far enough to unsnap it, then disengage the lower snap features of the trim cover from the adjuster.
- Remove the fastener (2b) that secures the front seat belt turning loop to the height adjuster on the inside of the upper B-pillar.
- Remove the seat belt turning loop from the height adjuster.
- Remove the upper trim (3b) from the inside of the B-pillar. Refer to PANEL, B-PILLAR TRIM, UPPER, REMOVAL AND INSTALLATION .
- Remove the two fasteners that secure the height adjuster to the inside of the upper B-pillar.
- Lift the height adjuster upward on the B-pillar far enough to disengage the hooks on the back of the adjuster from the B-pillar.
- Remove the height adjuster from the B-pillar.