Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2021 >> Renegade Islander, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (1.3L Cooling System) >> Engine >> Sensor, Coolant Temperature >> Removal And Installation

Removal And Installation

WARNING: This page is about a different variant/trim than selected.

REMOVAL 

  1. Remove the thermostat. Refer to THERMOSTAT, REMOVAL AND INSTALLATION  .
    GC0208130Courtesy of CHRYSLER GROUP, LLC
  2. Retract the clip (1a) and remove the engine coolant temperature sensor (1b).

INSTALLATION 

  1. Refit the engine coolant temperature sensor and engage the retaining clip using round-nosed pliers.
  2. Install the thermostat. Refer to THERMOSTAT, REMOVAL AND INSTALLATION  .
scientia non olet · About Mike's Workshop Manuals