Insulator, Engine Mount, Front: Removal

WARNING: This page is about a different variant/trim than selected.

Disconnect the negative battery cable.
Remove the intake manifold. Refer to REMOVAL .
Remove the accessory drive belt. Refer to 5.7L/6.4L .
Raise and support the vehicle.

Courtesy of CHRYSLER GROUP, LLC
Remove the belly pan retainers (1) and remove the belly pan.
NOTE:
The A/C system does not need to be evacuated or recharged for the A/C compressor positioning.
Disconnect and position aside the A/C compressor wiring harness.
Remove the A/C compressor from the engine block and position aside. Refer to COMPRESSOR, A/C, REMOVAL .
Lower the vehicle.

Courtesy of CHRYSLER GROUP, LLC

NOTE:
Left side shown, right side similar.
Remove left/right engine mount heat shield (3) retaining nuts (2) and remove the heat shields
Remove left/right engine mount lower retaining bolts (1).
For the right side engine mount replacement. Remove the generator. Refer to 6.4L .

Courtesy of CHRYSLER GROUP, LLC

NOTE:
Do not use air tools to install the engine lift fixture.
Install the Engine Lift Fixture (special tool #8984C, Fixture, Engine Lifting) (1), Engine Lift Adapter (special tool #8984-UPD, Adapter, Engine Lift) (2) and the Engine Support Fixture (special tool #8534C, Fixture, Driveline Support) (3).
Raise the engine to provide clearance to remove the engine mounts.
Raise and support the vehicle.

Courtesy of CHRYSLER GROUP, LLC

NOTE:
Left side shown, right side similar.
Remove left/right engine mount retaining bolts (1) and remove the engine mounts (2).

Courtesy of CHRYSLER GROUP, LLC

NOTE:
Left side shown, right side similar.
If necessary, remove engine mount to engine block mounting bracket retaining bolts (1) and remove the mounting brackets (2).