Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2021 >> Grand Cherokee Trackhawk >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (3.6L Engine (Service Information)) >> Engine Mounting >> Insulator, Engine Mount, Rear >> Installation

Insulator, Engine Mount, Rear: Installation

WARNING: This page is about a different variant/trim than selected.
GC0145019Courtesy of CHRYSLER GROUP, LLC
  1. On 4x2 vehicles if removed, install the rear engine mount bracket (2) with four bolts (1) tightened to the proper specifications. Refer to TORQUE SPECIFICATIONS  .
    GC0144303Courtesy of CHRYSLER GROUP, LLC
  2. On 4x2 vehicles, install the rear engine mount isolator (1) with three bolts (2) tightened to the proper specifications. Refer to TORQUE SPECIFICATIONS  .
    GC0145020Courtesy of CHRYSLER GROUP, LLC
  3. On 4x4 vehicles, install the rear engine mount isolator (1) with three bolts (2) tightened to the proper specifications. Refer to TORQUE SPECIFICATIONS  .
    GC0145018Courtesy of CHRYSLER GROUP, LLC
  4. Install the crossmember (1) with six bolts (3) tightened to the proper specifications. Refer to TORQUE SPECIFICATIONS  .
  5. Lower the transmission so the weight is resting on the isolator.
  6. Install two bolts (2) to the rear engine mount isolator and tighten to the proper specifications. Refer to TORQUE SPECIFICATIONS  .
    GC0145017Courtesy of CHRYSLER GROUP, LLC
  7. Install the left crossmember brace (1) with four bolts (2) tightened to the proper specifications. Refer to TORQUE SPECIFICATIONS  .
  8. Install the right crossmember brace (4) with two bolts (3) tightened to the proper specifications. Refer to TORQUE SPECIFICATIONS  .
  9. Install the skid plate, if equipped. Refer to PLATE, SKID, TRANSFER CASE, INSTALLATION .
  10. Lower the vehicle.
scientia non olet · About Mike's Workshop Manuals