Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2021 >> Grand Cherokee Trackhawk >> Repair and Diagnosis >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Electronic Control Modules (Service Information) >> Module, Power Sunroof (PSM) >> Removal >> Single Pane Sunroof

Single Pane Sunroof

WARNING:

Do not attempt to move or reposition the sunroof glass panel or drive cables with the sunroof motor and module unit removed. Damage to the vehicle, to the sunroof or personal injuries may result.

WARNING:

The Sunroof Motor And Module Initialization procedure must be completed any time a sunroof motor and module unit is replaced with a new component. Failure to perform this procedure may result in damage to the vehicle, to the sunroof or in serious or fatal injuries.

GC0170663Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Lower the front of the headliner to gain access to the sunroof motor. Refer to HEADLINER, REMOVAL .
  3. Remove the Sunroof Motor Mounting Screws (1) securing the sunroof motor.
  4. Lower the sunroof motor far enough to access and disconnect the wiring harness connector (2).
  5. Remove the sunroof motor from the vehicle.
scientia non olet · About Mike's Workshop Manuals