Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2021 >> Grand Cherokee Trackhawk >> Repair and Diagnosis >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Electronic Control Modules (Service Information) >> Module, HVAC >> Removal >> Removal - RHD

Removal - RHD

WARNING:

Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the radio. Refer to RADIO, REMOVAL .
    GC0184569Courtesy of CHRYSLER GROUP, LLC
  3. Disconnect the wiring harness connectors (1) from the HVAC module (3).
  4. Remove the fasteners (2) securing the HVAC module (3) to the instrument panel reinforcement.
  5. Remove the HVAC module from the instrument panel reinforcement.
scientia non olet · About Mike's Workshop Manuals