Power Seat Switch With Memory: Notes
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
- Remove the power seat switch from the power seat. Refer to SWITCH, SEAT, REMOVAL .
- Use an ohmmeter to test the continuity of the power seat switch. If not OK, replace the faulty power seat switch. If switch tests OK. Refer to DIAGNOSIS AND TESTING .
| Driver Seat Switch Continuity | ||
|---|---|---|
| Switch Position | Continuity Between | Resistance Value (± 5%) |
| Off | 10-4 | Open |
| Off | 10-11 | Open |
| Off | 1-4 | 47 Ohms |
| Off | 1-11 | 47 Ohms |
| Rear Tilt Up | 10-11 | 169 Ohms |
| Rear Tilt Down | 10-11 | 76 Ohms |
| Horizontal Forward | 10-11 | 43 Ohms |
| Horizontal Rearward | 10-11 | 10 Ohms |
| Recliner Up | 10-4 | 43 Ohms |
| Recliner Down | 10-4 | 10 Ohms |
| Front Tilt Up | 10-4 | 169 Ohms |
| Front Tilt Down | 10-4 | 76 Ohms |