Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2021 >> Cherokee High Altitude, Automatic T/Case Control >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.0L Engine (Service Information) >> Engine Mounting >> Insulator, Engine Mount, Left >> Removal

Insulator, Engine Mount, Left: Removal

  1. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  2. Remove the belly pan. Refer to BELLY PAN, REMOVAL .
  3. If equipped, remove the skid plate. Refer to PLATE, SKID, SIDE, REMOVAL .
  4. Remove the left front wheelhouse splash shield. Refer to REMOVAL .
    GC0183773Courtesy of CHRYSLER GROUP, LLC
  5. Remove the fastener (1) and remove the negative battery cable (2) from the transmission (3).
    CAUTION:

    Failure to remove the negative battery cable may overstress to the cable due to bending during service.

  6. Remove the battery and battery tray. Refer to TRAY, BATTERY, REMOVAL .
  7. Remove the Power Distribution Center (PDC). Refer to CENTER, POWER DISTRIBUTION (PDC), REMOVAL .
    GC0187122Courtesy of CHRYSLER GROUP, LLC
  8. Using a paint pen or marker, mark the location of the left isolator on the transmission bracket (5).
  9. Support the powertrain with a suitable jack.
  10. Remove the three isolator to bracket bolts (6, 7).
  11. Remove the isolator to strut tower bolt (2).
  12. Remove the two isolator to frame rail bolts (3) and remove the left engine mount isolator (1).
    GC0187185Courtesy of CHRYSLER GROUP, LLC
  13. If required, remove the three PDC mounting studs (2) from the left engine mount isolator (1).
scientia non olet · About Mike's Workshop Manuals