Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2021 >> Cherokee High Altitude, Automatic T/Case Control >> Repair and Diagnosis >> Accessories & Equipment >> Warning Systems >> Chime/Buzzer/Driver Assist (Service Information) >> Module, Park Assist >> Removal

Module, Park Assist: Removal

GC0160126Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the quarter trim panel from the left quarter inner panel (1). Refer to PANEL, QUARTER TRIM, REMOVAL .
  3. Disconnect the wire harness connectors (4) from the Park Assist Module (PAM) (3) connector receptacles on the left quarter inner panel just behind the left rear wheel house.
  4. Remove the fasteners (2) that secure the PAM to the weld studs on the quarter inner panel.
  5. Remove the PAM from the vehicle.
scientia non olet · About Mike's Workshop Manuals