Module, Digital Audio Broadcasting Antenna: Installation

Courtesy of CHRYSLER GROUP, LLC

1. Position the digital audio broadcast antenna module (2) into place on the driver side C-pillar.
2. Install and securely tighten the fastener (1).

   Courtesy of CHRYSLER GROUP, LLC

3. Connect the digital audio broadcast antenna cable (1) to the digital audio broadcast antenna module (2).

   Courtesy of CHRYSLER GROUP, LLC

4. Connect the two wire harness connector (1) to the digital audio broadcast antenna module (2).
5. Install the driver side upper quarter trim panel. Refer to PANEL, QUARTER TRIM, INSTALLATION .
6. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.