Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2020 >> Renegade Trailhawk >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Collision/Avoidance >> Electronic Control Modules (Service Information) >> Module, Glow Plug >> Removal And Installation >> Installation

Removal And Installation: Installation

GC0146750Courtesy of CHRYSLER GROUP, LLC
  1. Install the glow plug module (2) and securely tighten the fastener (1).
  2. Connect the glow plug module wire harness connector (3).
  3. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
scientia non olet · About Mike's Workshop Manuals